This shows you the differences between two versions of the page.
Previous revision | |||
— | manual:user_guide:functions:poi_alert [2022/04/08 15:44] (current) – mstupka | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | {{ : | ||
+ | ====== Point alert ====== | ||
+ | ---- | ||
+ | |||
+ | ===== What is it for? ===== | ||
+ | |||
+ | This feature **notifies** you (with beeping, a custom sound, vibration or a voice phrase) **when a point from a selected folder** of your user points **is nearby** (in the defined distance). Thanks to it, you don't have to check on the map all the time for geocaches near your hiking route, for example. | ||
+ | |||
+ | <wrap important> | ||
+ | ===== How to set it up? ===== | ||
+ | ==== 1. Select points ==== | ||
+ | * open **Folders** tab:\\ {{ : | ||
+ | * check the **folder with points** you want to be **notified of** | ||
+ | ==== 2. Set distance and alarm frequency ==== | ||
+ | * open **Basic** tab: \\ {{ : | ||
+ | * **Distance** - set how far from the selected point Locus starts the alert | ||
+ | * **Notify when point is in range** - check to switch sound/ | ||
+ | * **Notify once** - the alert goes on only once | ||
+ | * **Notify until stopped** - notification repeats in defined interval until stopped manually (red STOP button on screen) or when you're out of the alert distance. | ||
+ | ==== 3. Set type of notification ==== | ||
+ | Open **Notification** tab:\\ {{ : | ||
+ | === Settings of sound === | ||
+ | |||
+ | * **Disable** - all sounds are disabled, only screen and vibration alert work | ||
+ | * **Beep** - select number of beeps (1-10) | ||
+ | * **Select sound** - select any sound stored in your device memory | ||
+ | * **Text-to-speech** - enables voice prompts notifying of the name, distance, and direction of the point\\ Tap **Play** to check your sound settings. | ||
+ | === Settings of vibration === | ||
+ | Visible only when the vibrator is present (mainly in mobile phones) | ||
+ | * **Disable** - the device does not vibrate on notifications | ||
+ | * **Pattern** - set notification vibrating pattern, using three symbols: ' | ||
+ | ==== 4. Tap START in the topbar ==== | ||
+ | {{ : | ||
+ | ===== Setup change and point alert stop ===== | ||
+ | Point alert setup can be changed anytime, even when the feature is running. | ||
+ | * scroll down your system toolbar and tap the point alert notification\\ {{ : | ||
+ | * select **Edit** - you can change distance, type of notification and point folders. Then tap START again for the changes to take effect. | ||
+ | * tap **Terminate** to stop the point alert |